|
1928 Ford Coupe - Stock #926
This is the sport coupe model. Put the cloth top back on or make it into a roadster. Has rust on the bottom of the cowl and bottom of the quarter panels behine the doors. Otherwise looks quite solid. Floor structure looks good. This right fender was bad so a better one comes with it. Has a good North Dakota Title and delivery can be arranged for you!
SOLD! |
|
1934 Plymouth - Stock #351
Great project car! This is the "PE" Model with suicide doors. These are getting extremely hard to find in project cars. Has real decent floors. Will need the header above the windshield sectioned in but that is a very easy fix. Also has some lower rust in the right door. All in all, a very nice tudor sedan. Even the grill is repairable in this one! Garnish mouldings are there as well. Good North Dakota Title and delivery can be arranged for you.
Sold! |
|
1952 Dodge - Stock #2179
This is a very nice Dodge Coronet project car. It has a flathead 6 motor and the gyro-matic transmission. We did have the motor running. The floors in this car are very good. I see no rust in the car other than surface rust. It has all the glass with a crack in the right windshield. Very complete. It has an easily repairable dent in the right quarter panel. Do a little work on this one and you can drive it like it is. Good North Dakota Title and delivery is available.
SOLD! |
|
1953 Chrysler New Yorker - Stock #440C
If you are looking for an original piece of history, check out this New Yorker Deluxe! This is an original car just rolled out of 55 years of controlled temperature storage. This has the 331ci Hemi motor and the Fluid-matic transmission, and power steering. We never started the motor but it was started and driven many times over the years and turns over fine. Has the original paint and original interior. The headliner looks good. Very nice dash and gauges. Tune it up, polish the chrome, and drive it as a survivor. Good North Dakota Title and delivery can be arranged for you.
SOLD! |
|
1958 Chevrolet Wagon - Stock #2180
This is the rare 2 door DelRay Windowed Sedan Delivery. This one has the back seat and the rollup rear windows. Not many of these built. It has rust in the front floors and a very good used floor section is available locally. Also has damage to the left quarter panel and a used section is available as well. Quite complete. Lots of possibilities here! Good North Dakota Title and delivery is available.
SOLD! |
|
1937 Ford Truck - Stock #2267
This is a nice original truck for restoration or build your next rod. It has the flathead V-8. We never turned it over. Very solid truck. Has some rust showing in the filler above the windshield. Solid floors. Very nice grill needing only minimal repair. Quite complete. Good North Dakota Title and delivery is available.
SOLD! |
|
1941 International Pickup - #2134
Here is a good K-2 International for your next rod or rat rod project. Great patina! The fenders have some bumps and bruises from 75 years of use. The motor is a non-runner but probably could be rebuilt if you were doing a restoration. This is a very solid pickup with good floors and even the windshield header looks solid. Don't miss this one! Good North Dakota Title and delivery is available.
SOLD! |
|
1945 Studebaker Truck - #2120
Great little truck to rebuild or rod. It has the short 128 inch wheel base along with the flathead 6 motor and 4 speed transmission. We never tried the motor. The speedometer shows 19,571 miles. Has some floor rust and cab corner rust. Otherwise it looks quite solid. Not bad for dents. Real decent grill. In the spring of 1945 after the war, Studebaker built low numbers of the M-15 truck with 128 inch wheel base and the C-9 military cab. This cab has the fold out windshield, metal interior panels and painted bumpers. This is one of those trucks! Good North Dakota Title and delivery is available.
SOLD! |
|
1946 Chevrolet Truck - Stock #2286
This is an estate vehicle that was being used on the farm until recently. Has had a paint job and kept inside. Has a good running 6 cylinder motor, 4 speed transmission and 2 speed rear axle. I really don't see much for rust at all on this one and very few dents. It does have a repairable dent in the left fender and will need some repair to a few grill bars. The truck also has a good 12 foot box with hoist. Don't miss this one! Good North Dakota Title and we will assist with delivery.
SOLD! |
|
1946 Chevrolet 1 Ton Truck - Stock #2322
Very nice original Chevrolet 1 ton truck. This one even has the original paint. Has a running 6 cylinder motor and 4 speed transmission. Great one to do a little tune-up work and use it like it is. Hard to find a nicer original. Good N.D. Title. We can assist with transport.
SOLD! |
|
1948 Ford Panel - Stock #2090
This is the halfton version with a flathead V-8 and standard transmission. Has some lower body rust in the rear quarters. The roof seems look quite good. The floors look good and will only need minor repair. It has had the front door hinges cut out so will need some patch work there. Comes with an extra cowl for repair work. Good N.D. Title and delivery is available.
SOLD! |
|
1949 Ford COE - Stock #444c
The COE trucks are getting harder to find as the years go by. This '49 just came in. It is a shorty that was probably used for trailer hauling. Very complete. It has some lower rust in the cab corners and lower doors but all buildable. The floors look quite solid. It has the flathead V-8 motor. We never turned it over. Good North Dakota Title and delivey is available.
SOLD! |
|
1950 Chevrolet Pickup - Stock #2148
Nice 3600 Series Chevrolet Pickup for restoration. Has the 6 cylinder motor and 4 speed transmission. We never tried the engine. The pickup is quite solid with very little rust. It does have some rust above the windshield that will need attention and the cab corners are always thin. The drivers door was damaged and a good replacement was put on. Not bad for dents. Good North Dakota Title and delivery is available.
SOLD! |
|
1950 Chevrolet Truck - Stock #2182
This is the 6400 Series 2 ton truck with a 12 foot box and hoist. The box has a steel floor and the sides can be removed for a flatbed. The motor has been updated to the desirable 261 cubic inch 6 cylinder engine with a 4 speed transmission and 2 speed axle. The cab and front are nice on this truck with very little rust and very few dents. The left floor pan has rust and a replacement panel is included. Check this one out! Good N.D. Title and we will assist with transport.
SOLD! |
|
1951 Chevrolet Pickup - Stock #640
This pickup would be good for restoration, or do some mechanical work and drive it like it is. Also you could set it on an S10 chassis and drive it like that. Great patina! The 6 cylinder motor is free. Has some lower cowl and floor rust. Mostly original paint. Not bad for dents. Comes with a seat frame and springs. Good North Dakota Title and delivery is available.
SOLD! |
|
1951 Chevrolet Pickup - Stock #1476
This ia a 3600 Series project pickup with the 6 cylinder motor and 4 speed tranny. Looks like the motor is a 235. We never tried that at all. Will need a glass kit and a floor patch panel on the left side. These are all available and reasonable. Has the usual bumps and bruises from 70 years of use. Good North Dakota Title and delivery is available.
SOLD! |
|
1952 Ford Truck - Stock #2285
Here is a very nice original F-5 that is ready to go to work. Has a good running flathead V-8 motor and 4 speed transmission. The 14 foot Midwest box and hoist are in good condition. Good glass. Even the brakes work on this one. Original paint. There is a dent in the roof, hood and right door that will need repairing if you are going to restore the truck. Solid floors and very little rust at all. Hard to find a nicer original. Will have a good North Dakota Title and delivery is available.
SOLD! |
|
1955 Chevrolet Panel - #1333
This Panel is the half ton version with lots of possibilities. Has a non-running 6 cylinder motor. Has the usual windshield header rust and a little in the floor. The right fender will need replacing. The quarters have lower rust. Otherwise the body is quite good. The original rear wood floor is real decent. Comes with a good North Dakota Title and delivery can be arranged for you.
SOLD! |
|
1954 Dodge Pickup - Stock #2239
Nice halfton shortbox stepside for restoration or rodding. Will need a glass kit and a little rust work on the right floor footwell area. The bolt-in transmission cover is rusty as well. Has the flathead 6 motor and 4 speed transmission. We never tried the engine. Quite complete. The body looks good on this one. Good N.D. Title and delivery is available.
SOLD! |
|
1955 International Pickup - #2089
Nice R-120 Series IH Pickup for restoration. Very dry pickup. Nice floors. Has the 6 cylinder motor and 4 speed transmission. The motor will need a manifold and carburetor as the are gone. Has some dents from 55 years of use but not bad. 60,486 miles on the odometer. Great patina! Good North Dakota Title and delivery can be arranged for you.
SOLD! |
|
1956 International Truck - #2234
This is an S-160 Series Truck with an overhead valve 6 cylinder motor, 4 speed transmission and 2 speed axle. The motor is free but we never started it. The truck has a 13 1/2 foot box with a pto driven hoist. Very solid truck with some scale in the floor. Very few dents. Good North Dakota Title and delivery is available.
SOLD! |
|
1957 Chevrolet Pickup - #2156
This is the very desirable half ton short box pickup. It has the usual fender rust and windshield header rust. The header pieces are available. The floor foot area will need some rust work also. No motor or transmission. Nice box. Nice hood and grill. Projects like this one are getting hard to find. Good North Dakota Title and delivery is available.
SOLD! |
|
1965 Ford Truck - Stock #2190
This is a Ford 600 Series Truck fresh off the farm. It has the V-8 motor, 4 speed transmission and 2 speed axle. Also has a 15 foot Knapheide steel box and hoist. The sides are removable if you are wanting a flatbed. Nice cab with only minimal rust. Good North Dakota Title and delivery is available.
SOLD! |
|
1971 Dodge Truck - Stock #2258
Very nice original 2 ton truck with only 17,000 original miles. This is a one owner estate vehicle. The 212 h.p. 318 runs good. It has a 4 speed transmission and a 2 speed axle. Good tires, good glass and solid. The 14 foot box is galvanized so no rust problems. Hard to find a nicer original than this one! Good North Dakota Title and delivery is available.
SOLD! |
|
1971 Dodge Truck - Stock #2280
This Dodge Powerwagon will be an excellent one for restoration or just drive it like it is. Very original and very complete. Original paint. Has had replacement floor footwell sections put in and also a section of the box floor was replaced. Also has a little rust in the door tips. The 318 motor runs good and the 4 speed transmission and 4x4 seem to work good. New tires. Radio, heater and wipers work. These are getting hard to find in this condition. Good N.D. Title and delivery is available.
SOLD! |
|
1982 Dodge Ram Pickup - Stock #2269
This is the Power Ram with the slant 6 motor and 4 speed transmission. It is a 4x4 with lockouts. We had the motor running but it did have a rattle in it so will need some attention. Very solid body with some small dents from 40 years of use. Has the custom cab with radio, power steering and power brakes. Do some mechanical and drive it like it is. Comes with a good North Dakota Title and delivery is available.
SOLD! |