SOLD UNITS
 |
1965 Chevrolet Pickup - Stock #1970 This is the 10 Series Pickup. Very original pickup with a non-running 6 cylinder motor along with the standard 3 on the tree transmission. Rockers, roof header and rear of fenders will need rust repair. The floors are mostly pitted and will require a little patch work. A wood kit is needed for the box. These are getting to be a very popular series of GM Pickups. Good North Dakota Title and delivery can be arranged for you. SOLD! |
 |
1969 Chevrolet Pickup - Stock #2053 This is the C/20 Longhorn Edition. It was a very limited production model. All original body with minimal rust and not bad for dents. Will need a tailgate and wood kit for the box. The motor is free and should run. Has a 4 speed transmission. Shows 89,000 miles. Don't miss this very desirable pickup! Good Title and delivery is available. SOLD! |
 |
1969 Minneapolis Moline Tractor - Stock #428C Very nice Minneapolis Moline G900 Tractor. Shows 3319 hours. Starts and runs very good. The tires show their age but a very nice unit! SOLD! |
 |
1979 Jeep - Stock #1693 Looking for something different, check this one out! This is a postal Jeep manufactured by AM General with a Vin of DJ5G8185046. This one shows 90,000 miles and has a good body with very little rust. Nearly new tires. Right hand drive. Has a good running AMC 4 cylinder motor along with an automatic transmission. Lots of possibilities here! Good Title and delivery available. SOLD! |
 |
1948 IHC Truck - Stock #1975 Good International KB-5 for restoration. We had the flathead Green Diamond 6 cylinder motor running. Has a 4 speed transmission. Real decent body with very little rust. It does have rust in the filler above the windshield and has some dents above the backglass. Real decent grill with all stainless there except 1 bar. Decent floors with minor rust in the bolt-in pan. Good Title and delivery is available. SOLD! |
 |
1960 Ford Truck - Stock #1445 No Title on this one so we are parting it out. Only 14,000 miles. Same cab as the F-100. Has a good running Y block motor and a 2 speed axle. Has a small rust spot in the door tips. Otherwise, very solid with good floors. Will need some roof work on the cab. Very nice cab. SOLD! |
 |
1936 Plymouth - Stock #1991 This is a 1936 Deluxe 4 Door Sedan with a flathead 6 motor and a 3 speed standard transmission. It has some rust in the front floor foot area. Otherwise it has very little rust and very few dents. Quite complete. Great patina as it is. Has the crankout windhsield. Shows 81,000 miles. Great one to build. Good North Dakota Title and delivery is available. SOLD! |
 |
1937 Chevrolet - Stock #1032 Nice rat rod project car. These 4 door cars from the 30's and 40's are getting quite popular. Has some floor rust in the footwell areas. Otherwise looks decent. Lower doors look solid. Good North Dakota Title and delivery can be arranged for you. SOLD! |
 |
1937 Ford Sedan - Stock #1272 Very nice 1937 Humpback for restoration or rodding. Nice original body. Has a 60 h.p. V-8 motor and a standard transmission. Good trunk floors and rear floors. The footwell area of the front floors will need replacing and are available. Quite complete. Good North Dakota Title and delivery is available. SOLD! |
 |
1950 Shoebox Ford 2 Door - Stock #1282 This is the 2 door sedan model with the flathead 6 motor and the 3 speed standard transmission. We never tried the motor. It will need rockers and a little lower rust work. Also has some small rust holes in the floors that will need patchwork. The trunk floor looks quite solid. Not bad for dents. Real decent Shoebox Ford to build! Good North Dakota Title and delivery is available. SOLD! |
 |
1975 Nova - Stock #712 This car originally had the popular Huger orange paint. Has a non-running 6 cylinder motor and an automatic transmission. Has the usual rust in the fenders and lower quarters. The floors and rockers look real solid from the bottom. Good car to build! Good North Dakota Title and delivery is available. SOLD! |
 |
1929 Ford Truck - Stock #2033 Nice truck for restoration or rodding. Has the 4 cylinder A motor. Not much for rust in this one. Has a little lower body rust but not bad at all. Quite complete. Good Title and delivery is available. SOLD! |
 |
1938 International Pickup - Stock #2096 Nice International D-2 Pickup for restoration or do the mechanics and drive it like it is. Previous owner has sprayed some surface rust spots with primer so if you are looking for patina, this could be cleaned off. The pickup has a non-running flathead 6 motor and a 3 speed transmission. Not bad for rust and not bad for dents. Solid floors. This halfton shortbox shows 72,000 miles. Great little pickup for building! Good North Dakota Title and delivery is available. SOLD! |
 |
1941 Dodge Pickup - #2029 This is the Model WD15 with a Flathead 6 motor. Not much rust through in this one. Good floors. Solid above the windshield. Fenders have the usual bumps and bruises. Good project vehicle! Good Title and delivery is available. SOLD! |
 |
1941 Ford COE - #2083 Here is another COE for someones next rod project! The truck has the flathead V-8 motor. Real decent body with some roof damage and the usual bumps and bruises from 75 years of life. Has rust in the lower doors and cab corners. Otherwise looks quite good. The grill has some dents but very repairable. Good North Dakota Title and delivery is available. SOLD! |
 |
1946 Chevrolet Truck - Stock #1527 Nice truck for restoration. The 216 motor turns over and should run. Has a 4 speed transmission. Very little rust in this truck and not bad for dents. Solid floors. Chrome grill is real straight. Good North Dakota Title and delivery is available. SOLD! |
 |
1947 Diamond T Truck - Stock #2051 This truck is the Model 306H with a flathead 6 motor, 4 speed transmission and a 2 speed axle. The wheel base is about 149 inches. Very little rust through on this one but will need some metal work for dents. Very desirable model! Good North Dakota Title and delivery is available. SOLD! |
 |
1947 Dodge Truck - Stock #1817 Nice truck for restoration. This is a Model WFA32. Has a 12 foot box with a twin cylinder vertical lift. Has some rust above the windshield. Otherwise real dry. Has good floors. The flathead 6 motor is free. Has a 4 speed transmission and a 2 speed axle. Has some bumps and bruises from 70 years of use. The truck has a good Title and delivery can be arranged for you. SOLD! |
 |
1947 GMC COE - Stock #2077 Very nice COE ready to be on the road again. Has the 6 cylinder motor, 4 speed tranny and 2 speed axle. Shows 51,000 miles. Very nice floors. Nice grill. Needs a little rust work on the bottom of the doors and has a o little roof damage. Otherwise a very nice body. This is one you could drive with the patina it has. Original paint! We don't find them nicer than this anymore. Good Tile and delivery is available. SOLD! |
 |
1948 Chevrolet Pickup - Stock #777 Good 5 Window 3600 Series Pickup for restoration or rodding. Has a non-running 6 cylinder motor and a 4 speed transmission. Has the usual bumps and bruises from 70 years of use. Not bad for rust at all. Floors are quite good with only a little rust. Patch work is needed on the right side. All in all a good buildable pickup. Good North Dakota Title and delivery is available. SOLD! |
 |
1948 Chevrolet Pickup - Stock #1430 This is a nice 3800 Series Thriftmaster Pickup with the 9 foot bed. Real decent body. It will need the right and left floor pans which are about $47 per side and easy to put in. Has a real decent box. Rear fenders are rough but useable. Has the 216 motor and 4 speed transmission. We never tried the motor. Good North Dakota Title and delivery is available. SOLD! |
 |
 |
 |
 |
 |
 |
 |
 |